Expansion Kits Broaden the Range of Use

OP-SB85 [Expansion Kit for TTL, I2C, SPI] This expansion kit supports I2C clock synchronous communications and SPI communications used between LSI chips on printed circuit boards (PCB) besides HDLC communications and UART asynchronous communications at 3- and 5-V TTL signal levels. The kit incorporates a high-speed analog signal measurement function operating at a maximum of 40M samples per second, which is ideal for the analog waveform analysis of communications signals.	OP-SB85L [Expansion Kit for TTL, I2C, SPI] OP-SB85L is the interface expansion kit that has a port to measure TTL / CMOS signal level communications, and the one to measure the voltage of high-speed analog input. The port for TTL / CMOS supports the measurement of TTL / CMOS level communications that power supply system is from 1.8V to 5V. It is suitable for monitoring the communication between the LSI and the interface IC on the printed circuit board by directly probing into the lines. It supports the protocol of not only UART and HDLC but also I2C and SPI on monitoring and simulating. Furthermore, it has BURST measuring mode that captures data at all clock edges.
OP-SB85IR [Expansion Kit for IrDA, ASK] This expansion kit is provided with a probe pod for monitoring IrDA (SIR, MIR, and FIR) and ASK infrared communications. The kit has an IrDA monitor function that makes it possible to change communications speed automatically according to the IrLAP protocol and allows the seamless monitoring of infrared data, the mode of which changes from SIR (9600 bps) to FIR (4 Mbps). The kit has two optical emission levels (high and low levels), either one of which is selectable, and incorporates an analog waveform analysis function as well.	OP-SB85C [Expansion Kit for Current Loop] This expansion kit supports current loop communications. The kit incorporates a communications circuit with photo-coupler insulation and constant-current power supply of insulated type, thus realizing not only monitoring but also easy communications testing with passive or active current loop devices.
OP-SB87 [Expansion Kit for CAN, LIN] This expansion kit makes the measurement of up to 2 channels simultaneously by using Controller Area Network (CAN) communications (conforming to ISO11898/ISO11519-2 standards) used widely in FA systems and in-vehicle communications, and Local Interconnect Network (LIN) communications data in flexible connection. External signals in four lines can be measured as digital or analog signals simultaneously with the measurement of communications data.	OP-SB88 [Expansion Kit for FlexRay] The OP-SB88 is an expansion kit that allows the simultaneous monitoring of FlexRay communications data on up to two channels in real time. The FlexRay is anticipated as a next-generation high-speed in-vehicle network. The kit incorporates a monitor function that does not require complicated parameter settings and a simulation function with which the OP-SB88 works as a FlexRay communications node to transmit and receive data, thus powerfully supporting the initial development. The filter function and high-capacity memory greatly shorten the analysis time of trouble at the time of FlexRay system introduction. Furthermore, it incorporates a simultaneous measurement function for external signals, which makes it possible to investigate the relationship between the operation of peripheral devices and communications data.